Stun; 802.1X; Accounts; Global - Fortinet FON-670i User Manual

STUN

The STUN settings of the phone include:
• Server address — enter the given server address.
• Server port — default port is 3478.
• Local SIP Port —default port is 5060.

802.1x

You can enable and modify the following 802.1x settings:
• 802.1x Mode — contains the following options:
— Off
— EAP-MD5
— EAP-TLS
— PEAP-MSCHAPV2
• Identity
• Password

Accounts

These settings do not need to be adjusted when the phone is being used with a FortiVoice.
Configuration of these settings outside of the FortiVoice is not supported.

Global

The Global section contains advanced SIP settings that affect all accounts.
• Strict Branch — if enabled, the value of the branch must be after "z9hG4bK" in the VIA field
of a received INVITE message, or the phone will not respond to INVITE message.
• Enable Group — enables SIP Group Backup.
• Enable RFC4475 — if enabled the phone will support RFC4475, used for testing purposes.
• Registration Failure Retry Time — if registration should fail, the phone will try to register
again within the specified amount of seconds.
• Enable Strict UA Match — if enabled, the Request url of a received INVITE must match the
Server Address of the Account settings.

Account 1-6

The phone can be configured with up to 6 separate accounts manually. Each account contains
the same configuration options. Only one account is needed to operate with the FortiVoice and
will be automatically configured by the FortiVoice.
To configure the phone manually outside of use with FortiVoice, tap on which account you
would like to configure and enter the password as 123456. The following settings are available:
• Enable registration — this must be enabled in order for the phone to register with these
account settings.
• Server address — enter the address of the SIP server.
Settings Overview Page 9 FortiFone User Guide