Place And Secure Appliance - Vermont Castings NBST27 Installation And Operating Instructions Manual

SECURE APPLIANCE
WARNING
The fi replace and gas logs function as a system. If
the fi replace is spilling into the room (check with
a match or a smoke stick), reposition the damper
clamp until a positive draft is obtained by opening
the damper. If negative pressure in home prevents
having a positive draft, contact your dealer for
assistance.

PLACE AND SECURE APPLIANCE

1. Center the gas log unit in the fi replace or fi rebox. Make
certain the front feet of the grate sit inside the front
edge of the fi replace or fi rebox.
2. Anchor holes are located on the right and left sides of
the unit. After centering the grate correctly, mark the
hole locations on the fi replace/fi rebox fl oor. Drill two (2)
5/32" diameter holes approximately 1
3. Anchor the unit to the fi replace/fi rebox fl oor using the
screws provided. Figure 11
Proper installation of the grate is essential to prevent
any movement of the logs and controls during oper-
ation.
RIGHT CORNER APPLICATIONS
For right corner installations, the piezo ignitor
can be moved to the opposite corner of the ap-
pliance:
1. Remove wire from back of ignitor.
2. Remove two (2) screws holding piezo brack-
et.
3. Reattach bracket on the opposite corner
(where inlet fuel comes into the valve) by us-
ing two clearance holes on burner base.
4. Reattach wire to ignitor.
81D3032
You must secure the gas log heater to the fi replace
fl oor. If not, the entire unit may move when you
adjust the controls. Movement of unit may cause
shifting of the gas logs which leads to sooting and
improper burning. Grate movement could cause a
gas leak.
Special care is required if you are installing the unit
into a sunken fi replace. You must raise the fi replace
fl oor to allow access to gas log controls. This will
insure adequate air fl ow and guard against sooting.
Raise the fireplace floor using noncombustible
materials, as described in Placement in a Fireplace
with Restrictive Barrier on Page 6.
1 ⁄ " deep.
4
Figure 11 -
Secure Burner
NBST27 Unvented Gas Log Set
WARNING
Piezo Ignitor
(Original Location)
11