Executing The Diagnostic Test - Toshiba T200 User Manual

3.2

Executing the Diagnostic Test

To start the Diagnostic Test Program follow the steps below. The Diagnostic Test Program
can be executed with either the stylus or an optional keyboard.
1. Connect an optional 3.5-inch floppy disk drive.
2. Connect an external keyboard (Keyboard Test), RS-232C wraparound connector
(Async Test), parallel cable (Printer Test), PCMCIA wraparound connector
(PCMCIA Test), and printer wraparound connector (Printer Test) to each port.
3. Insert the Diagnostic disk and turn on the computer.
4. A cross-hair cursor will appear. Tap the cursor or press Enter .
The following menu will appear:
TOSHIBA Personal Computer XXXXX
Version 1.XX (C) Copyright TOSHIBA Corp. 19XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 - HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
↑ ↓ → ←
: Select items
NOTES: • To use the stylus, tap the appropriate number or command in the
menu at right. "Up-Aw" is up arrow, "Dn-Aw" is down arrow, "R-Aw'"
is right arrow, "L-Aw" is left arrow, "Esc" is escape and "BS" is back
space.
• To use a keyboard, set the highlight bar to the desired test, and press
Enter .
• To exit the menu, tap or press Esc . If a test program is in progress,
tap "Break" or press Ctrl+Break to exit the test program.
3-2
TEST
Enter : Specify
DIAGNOSTICS
Esc : Exit
Break Break
0 A
1 B
2 C
3 D
4 E
5 F
6
7 Up-Aw
8 Dn-Aw
9 R-Aw
R L-Aw
BS Esc
Enter Enter
T200, T200CS