Toshiba T200 User Manual page 142

Installing the T200CS Tablet
To install the computer's tablet, follow the steps below and refer to Figures 4-20 through 4-22.
1. Place the tablet on the display module. When you seat the tablet, align the holes at
each corner with the corresponding posts on the LCD module (Figure 4-22).
2. Lift the cables up and out of the way, then place the tablet cover on the tablet (Figure
4-21).
3. Place the middle frame on the display module, making sure the cabling is covered, then
snap the four latches into place (Figure 4-20).
4. Secure the middle frame with the two M2.5x4 screws (Figure 4-20).
5. Install the FL inverter board, lower system board, upper system board, backup battery,
RTC battery, back cover, HDD, optional PCMCIA card, optional memory card, and
battery pack as described in sections 4.2, 4.3, 4.4, 4.5, 4.6, 4.7, 4.8, 4.9 and 4.10.
4-32
T200, T200CS