Config Trapflags Authentication; Config Trapflags Bcaststorm; Config Trapflags Linkmode; Config Trapflags Multiusers - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

config trapflags authentication

This command enables or disables the Authentication Flag.
Default
Format

config trapflags bcaststorm

This command enables or disables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is enabled (see
"config switchconfig broadcast" on page 24).
Default
Format

config trapflags linkmode

This command enables or disables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled (see "config port
linktrap" on page 26).
Default
Format

config trapflags multiusers

This command enables or disables Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an
existing terminal interface session.
Default
Format

config trapflags stpmode

This command enables or disables the sending of new root traps and topology change notification
traps.
Default
Format
Switching Commands
enable
config trapflags authentication <enable|disable>
enable
config trapflags bcaststorm <enable|disable>
enable
config trapflags linkmode <enable|disable>
enable
config trapflags multiusers <enable|disable>
enable
config trapflags stpmode <enable|disable>
202-10010-01
7-21