Config Serial Baudrate; Config Serial Timeout; Show Serviceport; Config Serviceport Parms - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

config serial baudrate

This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
Format

config serial timeout

This command specifies the maximum connect time (in minutes) without console activity. A value
of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
Default
Format

show serviceport

This command displays service port configuration information.
Format
IP Address
Subnet Mask
Default Gateway
ServPort Configuration
Protocol Current
Burnedin MAC Address

config serviceport parms

This command sets the IP address, the netmask and the gateway of the router.
Format

config serviceport protocol

This command specifies the servicePort configuration protocol. If you modify this value, the
change takes effect immediately.
Format
7-16
9600
config serial baudrate <speed>
5
config serial timeout <0 - 160>
show serviceport
The IP address of the interface. The factory default value is 0.0.0.0
The IP subnet mask for this interface. The factory default value is 0.0.0.0
The default gateway for this IP interface. The factory default value is 0.0.0.0
Indicates what network protocol was used on the last, or current power-up cycle,
if any.
The burnedin MAC address used for in-band connectivity.
config serviceport parms <ipAddr> <netmask> [gateway]
config serviceport protocol <none|bootp|dhcp>
202-10010-01
Switching Commands