Transfer Upload Serverip; Transfer Upload Path - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Format

transfer upload serverip

This command sets the IP address of the server on which the file is located.
Note: This command is valid only when the transfer mode is TFTP. See "transfer upload mode" .
Default
Format

transfer upload path

This command sets the directory path used to upload the file. The switch "remembers" the last file
path used.
Note: This command is valid only when the transfer mode is TFTP. See "transfer upload mode" .
GSM7224 Layer 2 Managed Switch software supports the TFTP client. The TFTP client path
statement requirement is sever dependent. A path statement is generally required to set up the
TFTP client; however, the client path may remain blank.
See the example of the path setup.
TFTP Upload Example:
Table 3. TFTP Upload Example.
TFTP Server path
c:\tftp\
c:\
c:
GSM7224 Layer 2 Managed Switch software provides two methods to clear the directory path
statement.
• The
clear config
• The web browser clear command will remove the directory path statement.
Default
Format
Switching Commands
transfer upload mode <xmodem|tftp>
0.0.0.0
transfer upload serverip <ipaddr>
The TFTP upload example details three scenarios for TFTP client to server file
transfer.
In the example, the operator will upload the config.bin file from the switch to
the location c:\tftp\ on the server. The different scenarios are detailed below:
command will remove the directory path statement.
Blank
transfer upload path <path>
202-10010-01
TFTP Client path
blank
tftp\
\tftp\
7-75