Show Radius Stats; Clear Radius Stats; Config Dot1X Adminmode; Config Dot1X Port Initialize - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

show radius stats

This command displays the RADIUS statistics that are not related to a specific server or to the
accounting server.
Format
Invalid Server Addresses

clear radius stats

This command clears all RADIUS statistics.
Format

config dot1x adminmode

This command enables or disables authentication support on the switch. The default value is
disable. While disabled, the dot1x configuration is retained and can be changed, but it is not
activated.
Default
Format

config dot1x port initialize

This command begins the initialization sequence on the specified port. This command is only valid
if dot1x is enabled and the control mode for the specified port is 'auto'.
Format

config dot1x port reauthenticate

This command begins the reauthentication sequence on the specified port. This command is only
valid if dot1x is enabled and the control mode for the specified port is 'auto'.
Format
Switching Commands
show radius stats
The number of RADIUS Access-Response packets received from unknown
addresses.
clear radius stats
disable
config dot1x adminmode <enable/disable>
config dot1x port initialize <slot.port>
config dot1x port reauthenticate <slot.port>
202-10010-01
7-65