Show Eventlog; Show Msglog; Show Traplog - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

show eventlog

This command displays the event log, which contains error messages from the system. The event
log is not cleared on a system reset.
Format
File
Line
Task Id
Code
Time
Note: Event log information is retained across a switch reset.

show msglog

This command displays the message log maintained by the switch. The message log contains
system trace information.
The trap log contains a maximum of 256 entries that wrap.
Format
Message
Note: Message log information is not retained across a switch reset.

show traplog

This command displays the trap log maintained by the switch.
The trap log contains a maximum of 256 entries that wrap.
Format
Number of Traps since
last reset
Number of Traps since log
last displayed
Log
System Up Time
Trap
Note: Trap log information is not retained across a switch reset.
7-12
show eventlog
The file in which the event originated.
The line number of the event.
The task ID of the event.
The event code.
The time this event occurred.
show msglog
The message that has been logged.
show traplog
The number of traps that have occurred since the last reset of this device.
The number of traps that have occurred since the traps were last displayed.
Getting the traps by any method (terminal interface display, Web display, upload
file from switch etc.) will result in this counter being cleared to 0.
The sequence number of this trap.
The relative time since the last reboot of the switch at which this trap occurred.
The relevant information of this trap.
202-10010-01
Switching Commands