Turning The Power On Via A Lan; Other Notes On Operation - Fujitsu PRIMERGY RX600 S4 User Manual

Chapter 4 Operations after OS Installation

4.5.4 Turning the Power On via a LAN

You can turn the power on the server from a client (via a LAN) by utilizing the Wakeup on LAN (WOL)
function.
Be sure to install ServerView to control the power supply via a LAN.
When the power cable is disconnected from the server or the server is powered off due to power
interruption, restart the server. If not, the WOL function will be disabled.
The upper I/O riser card LAN port does not support the WOL function. When you use the WOL
function, use the onboard LAN port or the lower I/O riser card LAN port.
BIOS Setup Utility setting
To manage the power supply via a LAN, start up BIOS Setup Utility, and select the [Power] menu –
[LAN], and then set it to [Enabled]. The [Enabled] is set as the initial setting.
The setting on the OS takes priority in the setting of WOL enabled or disabled. For Windows, use
®
"Intel PROSet".

4.5.5 Other Notes on Operation

Unnecessary files
After OS installation is completed, folders named Runonce and Runonce 2 may be left in the drive
where the OS has been installed. Delete these folders since those are not necessary for the system
operation.
Automated system operation
When performing automated system operation, enhancement of the safety operation with this server
against unexpected accidents is necessary. Employ such measures as introducing disaster-prevention
provisions and stationing responsible for disaster prevention (such as a security guard or janitor) in the
building.
Unintentional power-off prevention
It is recommended to employ a dedicated power supply device (such as a power distribution board) to
prevent accidental power shut-offs.
94