Chapter 8 Operation and Maintenance
8.3 System Event Log
This section explains how to refer to and operate system event logs.
8.3.1 How to Refer to Event Logs
ServerView S2 is used for reference of system event logs. A summary of reference procedures is
described below. For details such as how to start up ServerView, refer to the "ServerView User's
Guide".
1
Start up ServerView S2.
2
Click the server to be referred from the ServerList.
3
Select [Configuration] – [Recovery] on the menu list on the left side.
The list of all the system event logs is displayed.
8.3.2 Deleting the System Event Log
Use BIOS Setup Utility to delete the system event logs.
1
Start up BIOS Setup Utility.
"7.2.1 Starting and Exiting BIOS Setup Utility" (pg.151)
2
Select the [IPMI] submenu on the [Server] menu.
3
Set [Clear System Event Log] item to [Enabled].
4
Save the configured value and exit BIOS Setup Utility.
196
Web interface of remote management controller may be used for the reference of system
event logs. To use remote management controller, refer to "Appendix E Remote Management
Controller" ( pg.220).