Sony mvc-cd250 Operating Instructions Manual page 105

'k-he lens gets kgged.
e You are not using an "InfoLITHIUW battery
pack.
e The battery level is low. (The Q indicator
appears.)
0 The AC power adaptor is not connected
securely.
* The built-in microcomputer is not working
properly.
* The built-m microcomputer is not working
properly.
0 The battery pack is discharged.
t Moisture condensation has occurred.
* You are playing back a file with an image six
larger than 2272x1704 (MVCCD400) or
1600x1200 (MVCCD250) that were recorded
by another camera.
* The image file has an error.
* The image was not recorded correctly.
= The disc is dirty
0 The disc may be scratched.
+ Use an "InfoLITHIUM"
battery pack (page 13).
+ Charge the battery pack (page 13).
+ Connect it securely to the DC IN jack of your camera and to a
wall outlet (wall socket) (page 16).
+ Turn the power off and then on after one minute, and check that
the camera works properly.
.-
+ Remove the battery pack, then install it again after about one
minute and turn on the camera. If the functions still do not work,
press the RESET button located on the bottom of the
camera
with a fine-tipped object, then turn the power on again. (When
you press the RESET button, all settings including the date and
time are cleared.)
+ Check the indicator (page. 124).
..-
+ Replace it with a fully charged battery or use the AC power-
adaptor (pages 13.16).
+ Turn off the camera and wait for about an hour at the room
temperature for the moisture to evanorate before use (Daze 118).
-
b
i
-
+ Clean the disc.
*Replace the disc.