Heart Rate Priority; Locked/Non-Locked Heart Rate; Signal Options - Nautilus TREADCLIMBER TC916 Owner's Manual

hEArT rATE PriOriTy

heart rate option
overview
both contact heart rate
and telemetry (e.g., polar
heart rate signal detection
is available. the default
priority of heart rate input
is "locKed input." if a
telemetry signal is detected
first, contact heart rate
signals are inhibited from
being detected throughout
the rest of the workout
session and vice-versa.
40

locked/non-locked heart rate

signal options

When the "EITHER INPUT" option is selected the heart rate source signal is not
fixed during the workout session (if the signal is lost either input will be valid). If the
"LOCKED INPUTS" option is selected then the heart rate source signal is locked on
®
)
the first detected signal during the workout. To set a heart rate signal input, or to
turn off the heart rate option all together, perform the following steps:
1. On the console keypad, press [Speed: UP], [3], [2]. At this point the screen
will display "HR INPUTS." Press [ENTER] to select this option.
2. There are five options to handle heart rate input signals. Press the [Speed:
UP] and [Speed: DOWN] keys to scroll through the options until you find the
option that you want. Press the [ENTER] key to select that option.
The options are as follows:
• locked inPuts - allows either telemetry or contact heart rate
signals to be detected. Once the console has detected a valid input signal
it will lock out the opposite type of signal for the duration of the workout
session. For example, if you start out using contact heart rate then you are
limited to using only contact heart rate during your workout session, even
if the signal is lost while performing the workout, and vice-versa.
• either inPut - allows either telemetry or contact heart rate signals
to be detected. Does not lock out a particular input signal for the entire
workout. This option will detect either input signal during a workout
session, but only one at a time, and only until the other signal terminates.
• telemetry only - locks out contact heart rate signals and will only
detect telemetry signals.
• hand only - locks out telemetry signals and will only detect contact
heart rate signals.
• both hr oFF - turns off the ability to detect any heart rate signal.
Used in rare situations where there is excessive interference with the
heart rate signals.
During workouts where heart rate is necessary, such as the HR Zone Trainer
and the Fitness Test, the console will pick up telemetry heart rate signals
so that the programs are not disabled.