Vermont Castings 0003380 Installation And Operating Instructions Manual page 11

Radiance Vent-Free Gas Heater
®
11. The rheostat control switch attaches to the left side of the
valve bracket at the front of the stove. (Fig. 13)
•
Remove retaining nut from shaft of rheostat. (if pre-
installed)
•
Insert the rheostat through the hole in the back of
the left side of the valve bracket, aligning the locator
pin with the smaller hole in that bracket.
•
Thread the retaining nut onto the shaft of the rheostat,
tightening with a wrench. Do not overtighten.
•
Attach the control knob to the rheostat shaft.
•
Use the wire tie to secure the fan and rheostat wire
harnesses together.
12. Plug the power cord into a standard grounded 110 volt
household outlet. If the fan control knob is not turned
to the OFF position, the fan will turn on when the
temperature at the snapstat reaches approximately 109°
F.
Retaining Nut
Control Knob
Fig. 13 - Attach rheostat to control panel. Valve may look different.
MOTOR
BLK
POWER
Fig. 14 - #2767 / FK26 Fan Wiring Diagram
ST196
FK26 fan diangram
11/99
11
Rheostat
ST347a
JUV
Disconnect power
before servicing.
FK28
BLK
rheostat install SNAPSTAT
9/21/00
WHT
ON/OFF
RHEOSTAT
!
The optional fan kit is equipped with a three-prong
(grounding) plug for your protection against shock hazard
and should be plugged directly into a properly grounded
three-prong outlet. Do not cut or remove the grounding
prong from this plug.
NOTE: If you are installing the fan kit after the stove is in its
final location, follow same steps mentioned previously with
the exception of disengaging only the right side of the outer
shroud.
WARNING
30005056