Optional Equipment; Motion I/O Connections - National Instruments Motion Control 7334 User Manual

Chapter 1 Introduction

Optional Equipment

Motion I/O Connections

7344/7334 Hardware User Manual
National Instruments offers a variety of products for use with the
7344/7334 controller, including cables, Universal Motion Interfaces
(UMIs), drive power amplifier units, and other accessories as follows:
• Cables and cable assemblies for motion and digital I/O
• RTSI bus cables
• UMI wiring connectivity blocks with integrated motion signal
conditioning and motion inhibit functionality
• Stepper and servo motor compatible driver amplifier units with
integrated power supply and wiring connectivity
• Connector blocks, shielded and unshielded 68-pin screw terminal
wiring aids
For more specific information about these products, refer to your National
Instruments catalog, on the Internet at
Instruments sales representative.
The external motion and digital I/O connectors on the 7344/7334 controller
are high-density, 68-pin female VHDCI connectors.
For custom cables, use the following mating connector from AMP
(part number 787801-01).
ni.com
1-4
, or call your National
ni.com