National Instruments Motion Control 7334 User Manual page 45

Appendix A Specifications
7344/7334 Hardware User Manual
Min pulse width...............................1 ms
Control.............................................Individual enable/disable, stop on
Trigger inputs
Number of inputs.............................4 (Encoders 1 through 4)
Voltage range...................................0 to 12 V
Input low voltage......................0.8 V
Input high voltage.....................2 V
Polarity ............................................Programmable, active-high
Min pulse width...............................83 ns
Capture latency................................<100 ns
Capture accuracy .............................1 count
Max repetitive capture rate..............1 kHz
Breakpoint outputs
Number of outputs...........................4 (Encoders 1 through 4)
Voltage range...................................0 to 5 V
Output low voltage ...................< 0.6 V at 64 mA sink
Output high voltage..................Open collector with built-in
Polarity ............................................Programmable, active-high
Inhibit/enable output
Number of outputs...........................4 (1 per-axis)
Voltage range...................................0 to 5 V
Output low voltage ...................< 0.6 V at 64 mA sink
Output high voltage..................Open collector with built-in
Polarity ............................................Programmable, active-high
Control.............................................MustOn/MustOff or automatic
input, prevent motion, Find Home
or active-low
3.3 kΩ pull-up to +5 V
or active-low
3.3 kΩ pull-up to +5 V
or active-low
when axis off
A-4 ni.com