National Instruments Motion Control 7334 User Manual page 61

T
toggle
torque
trapezoidal profile
trigger
TTL
V
V
V
CC
velocity mode
W
watchdog
word
© National Instruments Corporation
changing state from high to low, back to high, and so on
force tending to produce rotation
a typical motion trajectory, where a motor accelerates up to the
programmed velocity using the programmed acceleration, traverses at the
programmed velocity, then decelerates at the programmed acceleration to
the target position
any event that causes or starts some form of data capture
transistor-transistor logic
volts
positive voltage supply
move the axis continuously at the specified velocity
a timer task that shuts down (resets) the motion control board if any serious
error occurs
the standard number of bits that a processor or memory manipulates at one
time, typically 8-, 16-, or 32-bit
G-9
Glossary
7344/7334 Hardware User Manual