Problems - Sagem PHOTO EASY 260 User Manual

Liasse AZUR_GB.book Page 31 Lundi, 23. mai 2005 11:31 11
P
ROBLEMS
Remark: The printer is fitted with an automatic time-out to prevent overheating, this can be
tripped when performing large print jobs. The printer automatically restarts the
current print job as soon as the temperature drops back to normal.
P
ROBLEMS
No mains supply
(blank screen)
An error message is
displayed on screen
The printer was unplugged
during a print job
No photograph is printed
on a sheet
The photograph is marked
with a continuous line or a
lot of spots
No PC printing
The photos on the inserted
card are not displayed
The PC cannot read the
memory card
S
OLUTIONS
• Check that the power supply block is correctly plugged
into the mains.
• Check that the power supply connector is correctly
plugged into the printer.
• Check that the mains socket is live (check fuses and/or
circuit breakers of your installation as necessary).
• Refer to paragraph Error messages, page 32.
• Set the printer on/off switch to "o" and then reconnect
the mains lead.
• Switch on the printer and wait for the initialisation phase
to be completed.
• If a sheet of paper is jammed, carry out the procedure
(Refer to paragraph Paper jam, page 30).
• Restart printing.
• Are you using sheets that meet the technical
specifications (Refer to paragraph Technical data,
page 34).
• Have the sheets been inserted shiny face up?
• Clean the printhead (Refer to paragraph Cleaning the
print head, page 29).
• Check that the USB cable is correctly connected.
• Is the printer driver installed?
• Make sure that you are in Print mode, not Memory
Card Reader mode (see chapter 8).
• Images with a size of less than 76,800 pixels cannot be
printed from memory cards.
• However, these photos can be printed from a PC or via
direct infrared link (or bluetooth link with the optional
adapter).
• Make sure that you are in Memory Card Reader mode
(see chapter 8).
- 31 -