Signal Connections; I/O Connector - National Instruments DAQCard-1200 User Manual

Signal Connections

I/O Connector

Warning Connections, including power signals to ground and vice versa, that exceed any of
the maximum ratings of input or output signals on the DAQCard-1200 can
damage the DAQCard-1200 and the PC. National Instruments is
damages resulting from any such signal connections.
© National Instruments Corporation
This chapter describes the signals on the DAQCard-1200 I/O connector.
Figure 3-1 shows the pin assignments for the DAQCard-1200 I/O
connector. This connector is attached to the ribbon cable that extends from
the PC Card slot when the card is installed and the cable connected.
3-1
3
liable for any
NOT
DAQCard-1200 User Manual