Ac Power Cord - Teac CR-H226 Owner's Manual

C TAPE/AUX jacks
These jacks transmit an analog 2-channel audio
signal. Connect the components using RCA
cables.
Make sure to connect the cables as follows:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
< Be sure to insert each plug securely. To prevent
hum and noise, avoid bundling the signal
interconnection cables together with the AC
power cord or speaker cables.
White (L)
Red (R)
D
PHONO jacks
Connect the turntable's RCA pin cord to the
PHONO jacks.
Make sure to connect the cables as follows:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
< Be sure to insert each plug securely. To prevent
hum and noise, avoid bundling the signal
interconnection cables together with the AC
power cord or speaker cables.
< Moving Magnet (MM) cartridges can be used for
this unit.
E
SIGNAL GND
Connect the ground lead of the turntable to this
terminal.
< This is not a safety earth.
< If the turntable's ground lead is not connected to
this terminal, hum noise may be heard.
F DIGITAL OUT terminal
Connect the component with an optical cable.
DIGITAL OUT w DIGITAL IN (MD, etc.)
< When inserting the plug of the optical cable, the
protective shutter of the terminal will open and
you should hear it click into position when fully
inserted. Be careful that you do not force the
plug, because this could result in damage to the
protective shutter, the cable, or the unit itself.
White (L)
G

AC Power Cord

Red (R)
Plug this AC power cord into an AC wall socket.
< Unplug the power cord when you are not going
to use the unit for an extended period of time.
11