OfficeServ 7200-S
TECHNICAL MANUAL
7.1.8 Wall-Mounting Keysets
iDCS keysets come equipped with a reversible base wedge. To wall-mount a keyset, remove
the wedge from the keyset and remove the directory tray from the wedge. Mount the wedge
to the wall using one of the methods below
Use screw holes 1 and 2 to attach the base wedge to a standard electrical outlet box.
Use screw holes 1 and 3 to attach to a standard telephone wall-mount plate with locking pins.
This method can cause the keyset to wobble as the keyset feet do not fit securely to the
mounting surface.
Use screw holes 4 and 5 if you are mounting on dry wall with a hole in the middle for cable
access.
1
4
2
3
HOLES FOR MOUNTING SCREWS
NOTE: THE DIRECTORY CARD SLIDE TRAY IS NOT
Figure 7.9 Wall-Mounting a Keyset
(see Figure 7.9).
OR
OR
7.7
INSTALLATION
PART 7 MAY 2010
5
Home Page