Gplimt - Samsung OfficeServ 7200-S Installation Manual

OfficeServ 7200-S
TECHNICAL MANUAL
• For the use of an external rectifier: The shunt pins (J2, J3 and J4) are connected between
pin 2 and pin 3. There is no restriction on the use of an external rectifier because each of
them can supply the current of 10 A. Limit each current running through PLIM2 ports
below 0.1A and in the module below 1.6 A.
Each jumper is numbered in ascending order from the marked '1' in the following

3.3.14 GPLIMT

The Gigabit PoE LAN Interface Module TX (GPLIMT) board provides data transmission through
the intranet. Compared to the PLIM, the GPLIMT board comes with an additional GbE
interface and can provide 12 10/100 BASE-T interface ports and 2 1000 BASE-TX ports. The
GPLIMT board provides a simple switching hub function. Only one GPLIMT may be installed
per cabinet.
Major Functions
The major functions of the GPLIMT data board are as follows.
L2 Ethernet Switching

10/100 BASE Full/Half duplex auto-sensing

VLAN Networking (802.1q)

Packet Priority Control (802.1p)

Flow Control (802.3x)

Multi-Casting (IGMP Snooping)

IEEE 802.3af PoE (Power over Ethernet)

1
1
1
J4
J3
J2
Figure 3.33 Setting the Jumpers of PLIM2 Board
3.30
Home Page
INSTALLATION
PART 3 MAY 2010
figure.