Certificate Validation - Konica Minolta bizhub c280 User Manual

8
Item
[EAP-TTLS]
[anonymous]
[Inner Authentica-
tion Protocol]
[Server ID]
[Client Certificate]
[Encryption
Strength]
[Network Stop
Time]
[Stop Time]
8.10.4

Certificate validation

[IEEE802.1x Authentication Setting]
In the administrator mode of PageScope Web Connection, select [Network] ö [IEEE802.1x Authentication
Setting] ö [IEEE802.1x Authentication Setting].
Item
[Certificate Verifi-
cation Level Set-
tings]
[Validity Period]
[CN]
[Chain]
8-32
Description
Configure settings for EAP-TTLS.
Enter an anonymous name to be used for EAP-TTLS au-
thentication (up to 128 characters).
This item is available if [EAP-Type] is set to [EAP-TTLS] or
[Depend on Server].
Select an EAP-TTLS inner authentication protocol.
This item is available if [EAP-Type] is set to [EAP-TTLS] or
[Depend on Server].
Enter a server ID (up to 64 characters).
This setting is required if you verify the CN of the server
certificate.
Select whether to encrypt authentication information us-
ing client certificates of this machine. You can configure
this setting when client certificates are registered in this
machine.
If [EAP-Type] is [EAP-TLS], the client certificates are al-
ways required.
This setting can be configured even if [EAP-Type] is set to
[EAP-TTLS] or [PEAP].
Select an encryption strength level for encrypted commu-
nication with TLS.
• [Low]: Keys of any length are used for communication.
• [Mid]: Keys that are more than 56 bits in length are
used for communication.
• [High]: Keys that are more than 128 bits in length are
used for communication.
This item is available if [EAP-Type] is set to anything other
than [OFF] or [EAP-MD5].
If an authentication process does not succeed within the
specified time, all network communication will stop. To
specify the delay between the start of an authentication
process and the stop of network communication, select
this box.
Specify the delay (sec.) between the start of an authenti-
cation process and the stop of network communication.
To restart the authentication process after network com-
munication has stopped, turn the main power of this ma-
chine off and on again.
Description
To verify the server certificate, configure settings to verify
the certificate.
Select whether to check that the server certificate is within
the validity period.
Select whether to check that the CN of the server certifi-
cate matches the server address.
To check the CN, specify [Server ID].
Select whether to check that the server certificate chain
(certification path) is correct.
The chain is validated by referencing the external certifi-
cates managed on this machine. For details, refer to
page 8-35.
Using IEEE802.1X authentication
Prior check
Whether to verify the
CN of the server cer-
tificate
Prior check
bizhub C360/C280/C220
8.10