Sony VPH-G90E Installation Manual page 97

8
If they are not aligned, press the LIN key or the SIZE key and repeat
the adjustment by pressing the B or b key.
Each time you press the LIN or SIZE key, the COARSE mode and
FINE mode are selected alternately, and you can use the two modes
appropriately. The adjustment data is stored for each mode separately.
While you hold down the arrow key in the FINE mode, "f" is
displayed around the adjustment position.
9
If the CROSS HAIR pattern is off-centered on the screen, adjust the
centering again and repeat steps 1 to 8 for the horizontal scale
adjustment.
For details of the centering adjustment, see "1 Green CENT (centering)
adjustment" on page 95 (GB).
10
Press the LIN key.
11
Adjust with the V and v keys until parts (b
from the top and bottom ends of the screen to the first horizontal lines)
are of equal length.
V : The upper and lower horizontal lines are shifted
upward while the horizontal center line remains
unmoved.
v : The upper and lower horizontal lines are shifted
downward while the horizontal center line remains
unmoved.
12
Press the SIZE key.
13
Adjust with the V and v keys until parts (b) at the top and bottom are
about 15 to 20 mm long.
V : The vertical scale is expanded.
v : The vertical scale is reduced.
14
If they are not aligned, repeat steps 10 to 13.
15
If the CROSS HAIR pattern is off-centered on the screen, adjust the
centering again and then repeat steps 10 to 14 for the vertical scale
adjustment.
For details of the centering adjustment, see "1 Green CENT (centering)
adjustment" on page 95
on page 96
.
(GB)
) (distances
(GB)
97
Adjustments (GB)