Sony VPH-G90E Installation Manual page 49

@§ INPUT SELECT keys
Select the input signal.
VIDEO: Video or S video signal input from the
VIDEO connectors of the projector (VPH-G90U/
G90M) or the optional IFB-G90E Video Interface
Board (VPH-G90E)
SELECT VIDEO/S VIDEO: Selects video or S video
signal input from the VIDEO connectors after
pressing the VIDEO key.
A: The RGB, component or HDTV signal input from
the INPUT A connectors of the projector
B: The signal input from the INPUT B section when
the optional interface board other than the IFB-40
is installed
C: The signal input from the INPUT C section when
the optional interface board is installed.
D: This key does not function with this projector.
Note
To switch the input signal from the INPUT A, INPUT
B or INPUT C section to the S VIDEO IN (or Y IN/C
IN) connectors, first press the VIDEO key, then press
the SELECT VIDEO/S VIDEO key.
@¶ SYS SET (system set) key
When the PC-3000 Signal Interface Switcher is used in
the system, press the key to confirm the status of the
system, the settings of the interface board, and so on.
@• BLKG (blanking) key
Enters the blanking adjustment mode.
You can adjust the blanking with the four arrow keys.
For details, see "Blanking Adjustment" on page 124
@ª PATTERN key
Displays the internal test patterns of the projector.
Each press of the key advances the test pattern
sequentially.
In the focus, registration or white balance adjustment
mode, only the test patterns suitable for the adjustment
will be displayed.
For details, see "Test Patterns" on page 75
#º LCD LENS CONTROL keys
These keys do not function with this projector.
#¡ NORMAL key
Erases the test pattern or cancels the various
adjustment modes.
#™ MUTING keys
PIC (Picture): Cuts off the picture. To restore the
picture, press the key again.
AUDIO: This key does not funcion with this projector.
.
(GB)
.
(GB)
49
Before Adjustment (GB)