Sony VPH-G90E Installation Manual page 143

• Set the correct group and device index numbers and the switcher
number.
Do not set the same device index number or the same switcher number in
one group.
For example, if there are different pieces of equipment with the switcher
number 1, the error message will appear when the SYS SET key is
pressed.
Notes
• Do not set the same device index number on multiple projectors in the
same system.
• Set the switcher that outputs the signal to the projector to number 1.
PC-3000
PC-3000
Projector
Notes on connections when two or more switchers are used
• Mount the IFB-12/12A interface board to the slot 1 of the number (n)
switcher and connect the output connector of the number (n+1)
switcher to the IFB-12/12A.
• You can attach the IFB-12/12A signal interface board (when the IN/
OUT switch is set to OUT) only to the number 1 switcher.
*
Set this switcher to 1.
*
* PJ COM IN/OUT connections
143
Others (GB)