Log Set Installation / Removal - Pacific energy BROADWAY Installation And Operating Instructions Manual

Installation
1. Position rear log against the back rebox as seen in
Figure 66.
2. Position front log just behind the front burner tube as
seen in Figure 67.
3. Position log 3 with the thin end of the log resting on top
of the right end of the front log as seen in Figure 68.
4. Place ember pieces in front of the front log to hide the
burner as seen in Figure 69.
Note:
Do Not Block Burner Ports with Embers
Removal
1. Remove embers from replace.
2. Lift the decorative log off of the front log and remove it
from the rebox.
3. Lift the front log off of the burner and remove it from
the rebox.
4. Lift the back log over the pilot and burner and remove
from rebox.
Figure 65: Log set.
Figure 66: Rear log installation.
BDWY.BODYB
230216-44
BRNT.BODYB

Log Set Installation / Removal

Figure 67: Front log installation.
Figure 68: Decorative log installation.
Figure 69: Ember placement.
Figure 70: Complete log set.
33
5055.66-B