Log Set Installation/Removal - Pacific energy BROADWAY Installation And Operating Instructions Manual

Installation
1. Position rear log against the back firebox as
seen in Figure 39.
2. Position front log just behind the front burner
tube as seen in Figure 42.
3. Position log 3 with the thin end of the log
resting on top of the right end of the front log
as seen in Figure 44.
4. Place ember chunks in front of the front log to
hide the burner as seen in Figure 45.
Note: Do Not Block Burner Ports with
Embers
Removal
1. Remove embers from fireplace.
2. Lift the decorative log off of the front log and
remove it from the firebox.
3. Lift the front log off of the burner and remove it
from the firebox.
4. Lift the back log over the pilot and burner and
remove from firebox.
Figure 43: Front Log Installation
5055.66-E
Log Set Installation / Removal
Figure 45: Ember Placement
Figure 44: Decorative Log Installation
27
INSTALLER
INFORMATION
Figure 41: Log Set
Figure 42: Rear Log Installation
Figure 46: Complete Log Set
020215-36