Log Set Installation/Removal - Pacific energy BROADWAY Installation And Operating Instructions Manual

INSTALLER
INFORMATION
Installation
1. Position rear log against the back firebox as
seen in Figure 39.
2. Position front log just behind the front burner
tube as seen in Figure 40.
3. Position log 3 with the thin end of the log
resting on top of the right end of the front log
as seen in Figure 41.
4. Place ember chunks in front of the front log to
hide the burner as seen in Figure 42.
Note: Do Not Block Burner Ports with
Embers
Removal
1. Remove embers from fireplace.
2. Lift the decorative log off of the front log and
remove it from the firebox.
3. Lift the front log off of the burner and remove it
from the firebox.
4. Lift the back log over the pilot and burner and
remove from firebox.
Figure 40: Front Log Installation
Figure 42: Ember Placement
Log Set Installation / Removal
Figure 41: Decorative Log Installation
28
Figure 38: Log Set
Figure 39: Rear Log Installation
Figure 43: Complete Log Set