Table of Contents
Advertisement
Preparing for use
Configuration without ServerStart
Configuring the SATA RAID controller
For configuring the RAID controller, see section "Configuring the SATA RAID controller" above.
Configuring the PCI SCSI controller (for accessible drives only)
If your server is fitted with an additional PCI SCSI controller, you must configure it as described in the
related product documentation.
Installing the operation system
Ê
Insert the installation disk and the CD of the operating system you want to install.
Ê
Reboot the server.
Ê
Follow the instructions on the screen and in the manual for the operating system.
If your server is equipped with a RAID controller, then please read how to install the desired
operating system in the related manual.
Connecting external devices
CAUTION!
!
Read the documentation on the external device before connecting it. The power plug must
be removed before connecting external devices, apart from devices with USB interfaces.
Do not either connect or disconnect cables during storms.
Always take hold of the actual plug. Never unplug a cable by pulling the cable itself.
Connect and disconnect the cables in the order described below.
Connecting cables
Turn off all power and equipment switches.
Remove all power plugs from the mains outlets.
Plug all cables into the server and peripherals. You must observe the information provided in
the "Important notes" chapter.
Plug all data communication cables into the utility sockets.
Plug all power cables into the grounded mains outlets.
14
Connecting external devices
A26361-K831-Z502-1-7619
Advertisement
Table of Contents
