Connecting The Mouse; Connecting A Keyboard - Fujitsu Siemens Computers PRIMERGY Econel 50 Operating Manual

Connect the monitor, mouse and keyboard
It is recommended to connect the monitor power cable to the server monitor socket. The
i
monitor is then switched off automatically when you switch the server off.
The monitor is not switching off with the system if it is directly connected to a grounded
mains outlet. Switch off the monitor with its own ON/OFF button.
CAUTION!
!
The monitor power cable may only be connected to the server monitor socket if the
monitor current consumption is smaller than 1,5 A with 240 V or 3 A with 100 V. The
values for the monitor current consumption can be found in the technical data on the
monitor or in the operating manual for the monitor.

Connecting the mouse

Depending on the equipment level selected, your server will be supplied with a PS/2 mouse or a
USB mouse.
Connecting a PS/2 mouse
Ê
Connect the PS/2 mouse to the PS/2 mouse port
Connecting USB mouse
Ê
Connect the USB mouse to the USB port
If you do not attach a mouse at the PS/2 mouse port, you can disable the mouse controller
i
in the BIOS Setup in order to free the IRQ12 for a different application.

Connecting a keyboard

Depending on the equipment level selected, your server will be supplied with a standard keyboard or
a USB keyboard.
Connecting standard keyboard
Use the supplied keyboard cable only.
Ê
Plug the other end of the keyboard cable (square plug) into the socket on the underside of the
keyboard.
Ê
Plug the round plug of the keyboard cable into the keyboard port
Connecting USB keyboard
Use the supplied keyboard cable only.
Ê
Plug the other end of the keyboard cable (square plug) into the socket on the underside of the
keyboard.
Ê
Insert the rectangular USB plug of the keyboard cable into the USB port
A26361-K831-Z502-1-7619
of the server.
of the server.
Preparing for use
on the server.
of the server.
9