5. Use the flowchart in Figure A-2 to scan the frequency
data of the selected satellites.
TIP: If you know the satellite configuration data, you can configure the
satellite without scanning frequency data (see "Configuring Satellite
Settings" on page 72).
TIP: Scanning satellite frequencies might take up to 10 minutes.
Figure A-2 Scanning Frequency Data
<Default Display>
Menu
Install Satellite?
Yes
Next Return
Select Next until "Operations
Mode?" is displayed.
Operations Mode?
Yes
Next
Return
Get Antenna Status?
Yes
Next
Return
Control Antenna?
Yes
Next
Return
Man Control Antenna?
Yes
Next
Return
Select Next until "Sat
Frequency Scan?" is displayed.
Sat frequency Scan?
Yes
Next
Return
TracVision M5/M7 User's Guide
Appendix A - Advanced Settings and Functions
Select - or + as required,
then select Enter (valid range
is 01000 - 39999 kilosymbols
per second).
Symbol Rate: XXXXX
-
Enter
Select - or + as required,
then select Enter (valid codes
are 1/2, 2/3, 3/4, 5/6, 6/7, and
7/8).
Set FEC Code: X/X
-
Enter
Updating frequency
Please wait
Restart antenna?
Yes
+
+
No
71