KVH Industries tracvision m5 User Manual page 6

Step 4 – Configure the RF Tracking Parameters
Follow the steps below to set up the tracking parameters of the user-defined satellite(s).
1. Enter @DEBUGON.
2. Using the table below, enter the following @SATCONFIG command:
@SATCONFIG,a,b,c,d,e,f,g,h,i
Field Description
a User-defined satellite position stored in antenna library:
A = satellite position A
B = satellite position B
b User-defined satellite stored in antenna library:
98 = User1
99 = User2
c Frequency, MHz (00000 or 10700-12750)
d Symbol rate, kilosymbols per second (10000-45000; 33000 max if DVB-S2)
e FEC code:
12, 23, 34, 35*, 45*, 56, 67, 78, 89*, 51 (5/11)*, 91 (9/10)*, or 99 (auto)
f Network ID, hexadecimal (0x####)
g Polarization:
V = Vertical
H = Horizontal
R = Right
L = Left
h LNB down conversion frequency:
U = USA (DBS) (LO=11250 MHz)
L = Low (LO=9750 MHz)
H = High (LO=10600 MHz)
G = Latin America (LO=10500 MHz)
S = Sinosat (LO=11300 MHz)
i Decoding type:
0 = Turbo QPSK (DISH DVB-S2)*
1 = QPSK DCII (DigiCipher 2)*
2 = QPSK DTV (Legacy DSS)
3 = QPSK DVB (Legacy DVB)
4 = Turbo 8PSK (DISH DVB-S2)*
5 = LDPC 8PSK (Standard DVB-S2)*
6 = LDPC QPSK (Standard DVB-S2)*
* RF7 board required
AppNote0802 Revised
© 2008-2013 KVH Industries, Inc.
Page 3 of 6
Revised: 10/8/2013