KVH Industries tracvision m5 User Manual page 52

Step 2 - Configure the Receiver(s)
NOTE: If you are connecting multiple receivers, repeat this process for each
additional receiver. You will need to connect each receiver, one at a time, to
the RF1 cable and perform the steps below. Then, once you have completed
this process for each receiver, you can reconnect them as desired.
1. Ensure the receiver you wish to configure is connected
to the TracVision system's RF1 cable.
2. Turn on the TV(s) and receiver(s).
3. Using the receiver's remote, go to the "Point Dish/
Signal Strength" screen (press MENU, 6, 1, 1 on most
models).
4. Choose Check Switch, then press SELECT.
5. Choose Test, then press SELECT. The MCP displays the
"Check Switch Running" screen (see Figure 3-13).
Figure 3-13 Check Switch Running Screen
6. After waiting 15 minutes, check the MCP display. If the
"Please Run Check Switch" screen is displayed, repeat
Steps 3-5.
IMPORTANT!
Please be patient. The Check Switch test takes approximately 15
minutes to complete. Disregard any messages on the TV stating
the test is complete; the antenna must perform additional
operations before proceeding.
Figure 3-14 Please Run Check Switch Screen
Finding Satellites
Check Switch Running
Please Run
Check Switch
TracVision M5/M7 User's Guide
Chapter 3 - Settings
41