Replacing The Adf Rubber Pad - Muratec F-112 Series User Manual

Replacing the ADF Rubber Pad

You can purchase a ADF rubber assembly from a Muratec dealer.
1
Open the control panel by gripping its bottom and pulling it upward.
2
Disconnect the support on the left side of the machine from the control
panel and lift the control panel up to the complete open position
3
Remove the control panel from the machine by disconnecting the hinge
on the right.
N : Be careful no to disconnect the connector on the control panel from the
OTE
machine as it turns the LCD off.
4
Using a screw driver, press the slots on the ADF rubber plate to unlatch
the plate and the ADF rubber.
5
Align the holes on the new ADF rubber and the plate and inset the tabs
on the plate into the slots on the machine. Press them until they are
latched.
6
Replace the control panel by connecting the hinge on the right first
then inserting the left arm while pushing the control panel to the right.
7
Reconnect the support and the control panel, then close the control
panel firmly until it clicks into place.
5.9
M
AINTENANCE
5