Removing A Compact Flash Memory Card - Extreme Networks BlackDiamond 8800 Hardware Install Manual

To install the memory card:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle on the chassis front panel.
2 Locate the compact flash slot on the MSM
Figure 73: Typical Compact Flash Slot Location (BlackDiamond 8800 Series MSM)
3 Hold the memory card between your thumb and forefinger.
The side with the ridge faces toward the bottom of the chassis.
4 Slide the card into the compact flash slot until you feel resistance.; a portion of the card will protrude
from the slot.
5 Carefully push the card until it is seated into the slot. The card should be fully inserted, or seated,
inside the slot.
6 To verify that the card is fully seated, use the show memorycard command.

Removing a Compact Flash Memory Card

You do not need to power off the system or remove the MSM from the chassis to remove an external
compact flash memory card.
You need an ESD-preventive wrist strap to remove a compact flash memory card.
To remove the memory card:
1 Use the eject memorycard command to ensure that you will not lose any data when you remove
the card.
After you use the eject memorycard command, you can physically remove the card from the
compact flash slot on the MSM. For more information about the eject memorycard command,
see the ExtremeXOS User Guide.
2 Attach the ESD-preventive wrist strap to your wrist and connect the metal end of the strap to the
ground receptacle on the chassis front panel.
3 Locate the black release pin just above the compact flash slot.
4 Press the release pin until the card releases from the slot.
The card releases to an intermediate position; the card remains partially inserted but is no longer
seated in the slot.
5 Remove the card completely and place it in a safe location.
BlackDiamond 8800 Hardware Install Guide
Installing Modules and Establishing Initial Management Access
(see the following figure).
100