Chapter 13: Repacking A Blackdiamond 8800 Series Chassis; Safety Information; Required Tools And Equipment - Extreme Networks BlackDiamond 8800 Hardware Install Manual

13
Repacking a BlackDiamond 8800
Series Chassis

Safety Information

Required Tools and Equipment

Repacking the BlackDiamond 8810 Chassis
Repacking the BlackDiamond 8806 Chassis
This chapter describes how to remove a BlackDiamond 8800 Series chassis from an equipment rack
and repack the chassis for shipping back to Extreme Networks. To repack a BlackDiamond 8800 Series
chassis, use the original shipping crate or box and packing materials.
Note
Read the information in this chapter thoroughly before you attempt to remove a
BlackDiamond 8800 Series chassis.
Safety Information
Before you begin to repack the BlackDiamond 8800 Series switch, read the safety information in
Information on page 141.
Caution
Correct lifting procedures for a BlackDiamond 8800 Series chassis require two or more
people.
Before you lift a BlackDiamond 8800 Series chassis, make sure the chassis is empty to
prevent unnecessary weight. This will also prevent damage to the system components due to
possible chassis flex when it is being lifted.
Required Tools and Equipment
You need the following tools and equipment to repack a BlackDiamond 8800 Series chassis:
•
ESD-preventive wrist strap
•
Support bracket that was shipped with the chassis
•
Four rack-mount screws appropriate to your organization's equipment rack
•
Screwdriver appropriate to the rack-mount screws
•
Original packing materials from the chassis
•
Packing tape
•
Nylon strapping and crimping tool
BlackDiamond 8800 Hardware Install Guide
Safety
133