Blackdiamond 8806 Psu Cover - Extreme Networks BlackDiamond 8800 Hardware Install Manual

5 Push the top of the cover into place against the front of the switch until the latching tabs click into
place (see the following
Figure 93: Latching the PSU Cover
Removing the BlackDiamond 8810 PSU Cover
To remove the PSU cover:
1 Press down on the latching tab at each side of the top.
2 With the latching tabs pressed down, pull outward on the top edge of the cover to disengage it from
the switch chassis.
3 Lift the cover off the AC cord retainer.

BlackDiamond 8806 PSU Cover

The BlackDiamond 8806 PSU cover fits onto the AC power cord management bracket and snaps into
place on the front of the BlackDiamond 8806 switch. The PSU cover kit includes the following parts
(Figure 94: BlackDiamond 8806 PSU Cover Kit
•
PSU cover
•
AC power cord management bracket with captive retaining screws
BlackDiamond 8800 Hardware Install Guide
figure).
on page 118):
BlackDiamond PSU Covers
117