Sicherheitshinweise - Extreme Networks BlackDiamond 8800 Hardware Install Manual

limited to gigabit interface converters (GBICs), small form factor pluggable (SFP) modules (or mini-
GBICs), QSFP+ modules, XENPAK transceivers, and XFP laser optic modules.
Warning
Laser optic modules become very hot after prolonged use. Take care when removing a laser
optic module from the module or option card. If the laser optic module is too hot to touch,
disengage the laser optic module and allow it to cool before removing it completely.
Warning
When working with laser optic modules, always take the precautions listed below to avoid
exposure to hazardous radiation.
•
Never look at the transmit LED/laser through a magnifying device while the transmit LED is powered
on.
•
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are
powered on.
•
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the
beam when optical connections are unplugged.
•
Never alter, modify, or change an optical device in any way other than suggested in this document.
Note
Extreme Networks optical modules are tested to work in all supported Extreme Networks
switches. We recommend that all customers use Extreme Networks optical modules in their
Extreme Networks switches. Extreme Networks assumes no liability for third-party optical
modules. Although Extreme Networks does not block third-party optical modules, we cannot
ensure that all third-party optical modules operate properly in all Extreme Networks switches.
The customer assumes all risks associated with using third-party optical modules in Extreme
Networks switches.
GBIC, SFP (Mini-GBIC), XENPAK, and XFP Regulatory Compliance
Extreme Networks pluggable optical modules meet the following regulatory requirements:
•
Class 1 Laser Product
•
EN60825-1+A2:2001 or later, European laser standard
•
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
•
Application of CE Mark in accordance with 89/336/EEC EMC and 73/23/EEC Low Voltage Directives
•
UL and/or CSA registered component for North America
•
47 CFR Part 15, Class A when installed into Extreme products

Sicherheitshinweise

Warning
WARNUNG! Vor der Installation der Produkte von Extreme Networks sind die nachfolgenden
Sicherheitshinweise aufmerksam zu lesen. Die Nichtbeachtung dieser Sicherheitshinweise
kann zu Verletzungen oder Schäden an der Ausrüstung führen.
BlackDiamond 8800 Hardware Install Guide
Safety Information
146