Specifications; Ec Declaration Of Conformity - Makita 6095D Instruction Manual

ENGLISH (Original instructions)
1-1. Set plate
1-2. Battery cartridge
2-1. Switch trigger
3-1. Reversing switch
4-1. Arrow

SPECIFICATIONS

Capacities
-1
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
Noise
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode: Drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Explanation of general view
4-2. Speed change knob
4-3. Low speed
4-4. High speed
5-1. Adjusting ring
5-2. Pointer
Model
Steel
Wood
Wood screw
Machine screw
High
)
Low
Overall length
Net weight
Rated voltage
) : 70 dB(A) or less
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h,D
2
ENE034-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG103-2
the times when the tool is switched off and when it
is running idle in addition to the trigger time).

EC Declaration of Conformity

We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine: Cordless Driver Drill
Model No./ Type: 6095D
ENG202-3
are of series production and
sum)
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
ENG901-1
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
000230
3
6-1. Tighten
6-2. Sleeve
6-3. Ring
6095D
10 mm
18 mm
5.5 mm x 55 mm
6 mm
0 - 1,100
0 - 400
270 mm
1.8 kg
D.C. 9.6 V
Corporation as the
30th January 2009
Tomoyasu Kato
ENH101-12
responsible