Appendix F - Mmh2834 Modem Commands - Multitech DataTalker DT101 Owner's Manual

Appendix F - MMH2834 Modem Commands

F.1 Introduction
Before you can enter commands for the MMH2834 internal composite link modem, you must
access the modem using the composite link access enable command (#CLA1). When you have
configured the MMH2834 modem, disable access from the command port to the composite link
using the composite link access disable command (#CLA0). The following sections describe the
MMH2834 modem commands.
MMH2834 Command Summary
TYPE
Dial
(Section F.2)
Modify Dialing
Procedures
(Section F.3)
Memorize Phone D...N
Numbers
(Section F.4)
Store Modem
Configurations
and Defaults
(Section F.5)
Configure
Command
Responses
(Section F.6)
Condition
Phone Line
(Section F.7)
RS232C Interface &D
(Section F.8)
COMMAND DESCRIPTION
D Dial
A: or : Continuous Redial
$D DTR Dialing
N Dial a Stored Number
P/T Pulse/Tone Dialing
&P Set Pulse Dial Ratios
, Automatic Pauses in dialing
Y Long Space Disconnect
W Wait for New Dial Tone
R Reverse Mode of Operation
! Flash On Hook
$ AT&T "Calling Card" Tones
@ Quiet Answer
Store Phone Numbers
NN Number Linking
L List Numbers Stored in Memory
&F Load Factory Defaults
&W Store Configuration & S-Register Parameters
Z Reset Modem
V Result Code Terse/Verbose
&M Synchronous/Asynchronous Mode Select
&X Synchronous Transmit Clock Select
Q Result Codes Enable/Disable Response
&Q Result Code Selection
E Echo Command Characters
V Result Code Terse/Verbose
X Result Code...Basic/Extended/Call Progress
&T Remote Digital Loop Signal
#T Enable/Disable Trellis Coded Modulation
Data Terminal Ready Control
Appendix F - MMH2834 Modem Commands
127