Multitech DataTalker DT101 Owner's Manual page 108

DataTalker Owner's Manual
Voice/Fax Channel 1 Configuration
1 - Destination Channel
2 - Digitizing Rate
3 - Output Level Atten.
4 - Input Level Gain
5 - Silence Suppression
6 - Local Interface Type
7 -
8 -
9 -
10 -
11 - Remote Interface Type
12 -
13 -
14 -
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
7 Verify the voice/fax channel configuration. To change the configuration, enter the appropriate
option numbers.
Options 1 through 10 are for the local interface. Options 11 through 14 are for the remote
interface. Note that the remote interface options do not actually change the remote interface;
they only tell the local DataTalker how the remote interface is configured. Any changes in the
remote interface must be done at the remote site. See Chapter 6 for descriptions of the
Voice/Fax Channel 1 Configuration menu options.
8 When all the options for the voice/fax channel are set, enter S and press ENTER to store all
configurations. Then enter M and press ENTER to return to the Main Menu.
9 Disconnect the terminal or PC from the command port and place DIP switch position 3 in the
up (OPEN) position to change the command/data port over to a data channel.
108
: 1
: 9600
: 12
: 03
: Off
: FXS
Ground/Loop Start (FXS) : Loop
2 or 4 Wire (E&M) : N/A
Dialtone/Wink (E&M) : N/A
Wink Timer (E&M) : N/A
: FXS
Ground/Loop Start (FXS) : Loop
2 or 4 Wire (E&M) : N/A
Dialtone/Wink (E&M) : N/A