Multitech DataTalker DT101 Owner's Manual page 30

DataTalker Owner's Manual
Data Port Configuration
1 - Async/Sync:
2 - Speed:
3 - Clocking:
4 - Idle Condition:
5 - NRZ/NRZI Encoding:
6 - CRC Preset:
7 - Inter-frame Timer:
S - Store All Configuations
M - Main Menu
P - Previous Menu
Selection : _
Press P to return to the Data Port Configuration menu, enter S to store all configurations, and
then press P again to return to the previous menu. At the Configurations menu, enter 2 and press
ENTER.
The Voice/Fax Channel 1 Configuration menu is displayed. For LAN 1, set voice/fax channel 1 for
an FXO connection as the local interface type (option 6), and keep the default FXS as the remote
interface type (option 11). LAN 2 must be set just the opposite (FXS for the local interface and
FXO for the remote interface). For the other selections, accept the defaults .
Voice/Fax Channel 1 Configuration
1 - Destination Channel
2 - Digitizing Rate
3 - Output Level Atten.
4 - Input Level Gain
5 - Silence Suppression
6 - Local Interface Type
7 - Ground/Loop Start (FXS) : Loop
8 - 2 or 4 Wire (E&M)
9 - Dialtone/Wink (E&M)
10 - Wink Timer (E&M)
11 - Remote Interface Type
12 - Ground/Loop Start (FXS) : Loop
13 - 2 or 4 Wire (E&M)
14 - Dialtone/Wink (E&M)
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
Enter S and press ENTER to store all configurations for LAN 1.
Set up LAN 2 in the same manner, but switch the local and remote interface types (FXS for the
local interface and FXO for the remote interface). When you have finished selecting the LAN 2
options, enter S to store all configuration. Enter P to return to the Configurations menu.
At the Configurations menu, enter 3 and press ENTER to display the composite link configuration
menu.
30
Sync
19200
Internal
Flags
NRZ
All 1s
Off
: 1
: 9600
: 12
: 03
: Off
: FXS
: N/A
: N/A
: N/A
: FXS
: N/A
: N/A