Power Draw; Mtcdt-L4N1 With Modem And No Accessory Cards - Multitech Conduit MTCDT-L4N1 Hardware Manual

SPECIFICATIONS
Label Name
Signal Signal Strength
If a cellular radio is installed, the typical LS (Link Status) LED behavior is the following:
OFF - No power to the cellular radio
Continuously Lit - Not registered
Slow Blink (-0.2Hz) - Registered or connected
On the back of the Conduit, the RJ-45 Ethernet LEDs (located at the bottom of the connector) are defined as
follows:
Orange LED (lower-left) indicated activity/link. Blinks when there is transmit and receive on the
Ethernet link. It shows a steady light when there is a valid Ethernet connection.
Green LED (lower-right) indicates link speed. Lit when Ethernet is linked at 100Mbps. If not lit, Ethernet
is linked at 10 Mbps.

Power Draw

MTCDT-L4N1 with Modem and No Accessory Cards

Radio Protocol Sleep Mode
Current
9.0 Volts
WCDMA 1854 NA
Mhz WS46=22
LTE freq Band NA
14 793 Mhz
12.0 Volts
WCDMA 1854 NA
Mhz WS46=22
LTE freq Band NA
14 793 Mhz
24.0 volts
WCDMA 1854 NA
Mhz WS46=22
LTE freq Band NA
14 793 Mhz
1
Max Power: The continuous current during maximum data rate with the radio transmitter at maximum power.
12
Description
These 3 LEDs display the strength of the cellular signal. Present on the
Conduit mPower model only.
Cellular Call Average
Box Measured
Connection No Current at
Data (mA) Max Power
1
(mA)
165 635
163 617
136 488
136 478
93 276
90 274
Conduit
TX Pulse (Avg)
Amplitude
Current
728
704
572
564
356
332
®
Cat 4 for North America MTCDT-L4N1 Hardware Guide
Total Inrush Total Inrush
Charge Charge
Measured in Duration
MilliCoulombs during
2
(mC) Powerup
(Inrush
Duration)(mS)
4.87 9.49
4.87 9.49
4.46 8.44
4.46 8.44
4.03 17.5
4.03 17.5