Shunt - Multitech DataTalker DT101 Owner's Manual

DataTalker Owner's Manual
5.3 V.35 Shunt
Table 5-2. V.35 Shunt Procedure
Step Procedure
1 Desktop version: Unplug the power supply from the back of the unit.
Rack version: Remove the unit from the RackTalker rack. Go to step 4.
2 Desktop version only: Turn the unit upside down and remove the two cabinet mounting
screws from the middle of the cabinet.
VOICE /
FXS
FAX 2
DATA/ VOICE /
XMT RCV FC COM ORIG FXS
COMMAND FAX 1
Figure 5-11. Cabinet Mounting Screws
3 Desktop version only : Turn the cabinet right-side up, tilt the back down slightly, and the base
unit will slide out of the cabinet.
4 Desktop and rack versions: Place the unit with the LEDs facing you.
5 Pry the shunt out of the RS232 socket and insert it into the V.35 socket. Rack version: Go to
step 8.
RS-232

Shunt

V.35
Shunt
Figure 5-12. V.35 Shunt Location (Desktop Version)
6 Desktop version only: Slide the base back into the cabinet with the LEDs toward the front and
the rear grounding tabs pressing against the side of the cabinet.
7 Desktop version only: Turn the unit upside down and replace the two cabinet mounting
screws.
8 Desktop version: Turn the unit right-side up and reconnect the power supply.
Rack version: Slide the unit into the RackTalker card guides and, after ensuring that the
DataTalker is fully seated, fasten the retaining screws.
60
Data / Voice / Fax Concentrator
FXO E&M FAX XMT RCV XSG RSG RXT FCR RD TM V35 EXT MDM DSU TA
COMPOSITE
LINK 28.8 DTR DBUP OH
STATUS
FXO E&M FAX XMT RCV XSG RSG CD RCV XMT CTS 56 RTS NS OOS 2B
101 MDM / TA
Cabinet
Mounting
Screws (2)