Multitech DataTalker DT101 Owner's Manual page 34

DataTalker Owner's Manual
Composite Link Settings - Internal TA
1 - On-Line XMT Rate:
2 - Configure TA
3 - DOD/DOI:
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
The terminal adapter menu displays the transmit rate and option 2 allows you to configure the
terminal adapter. Use option 2 (Configure TA) to access the terminal adapter's built-in
configuration menus (refer to the ISDN Terminal Adapter Owner's Manual for details). The Flush
Time option is used only with an Alpha microcomputer or Wyse terminal. Enter S and press
ENTER to store all configurations.
This completes the configuration of both DataTalkers. Disconnect the data/command port from
the terminal or PC and connect it to the data computer or PC. Place DIP switch position 3 on
both DataTalkers in the up (OPEN) position to change the data/command port over to a data
channel.
34
128000
Off