Tascam DR-05 Owner's Manual page 75

3 Press the MARK button at the end point
of the section that you want to play
repeatedly. This position is set as OUT
(end) point, and loop playback of the
section between the IN and OUT points
starts.
Then, appears at the corresponding
point under the playback indicator bar.
During loop playback the
appears.
Press the PB CONT button to return to the
Home Screen while maintaining the I/O and
loop settings effective. Even after returning to
the Home Screen, the
shown, along with the
at the points corresponding to the IN and OUT
points under the playback indicator bar.
indicator also
icon continue to be
and marks shown
NOTE
• The pop-up message of "I/O Too Short" appears if the
section between the IN and OUT points is too short. Set
them again. The section should be 1 second or longer.
MARK button again to clear the IN and OUT
• Press the
points.
• To stop loop playback, press the MENU button when the
Playback Control screen is open. Press the MENU button
again to start loop playback between the set IN and OUT
points.
• If you set one of the repeat mode, loop playback is
canceled.
• You cannot set the IN and OUT points in different files.
• IN and OUT point settings are lost when you select a
different file.
• Accurate assignment of IN and OUT points is not always
possible for variable bit rate (VBR) MP3 files.
6–Playback
75
TASCAM DR-05