Installer Quick Menu - Paradox Magellan MG5050 Programming Manual

Installer Quick Menu

Zones
Step Action
1
+ [
INSTALLER CODE
2 [ ]
ZONE NUMBER
3 [E
NROLL OR ERASE ZONE
4 [ ]
ZONE TYPE
5 Assign Partition
[1] and/or [2] + [
Notes Partition 2 status LEDs, display the signal strength of the selected wireless zone
(4 LEDs = best signal; 1 LED = weak signal; No LEDs = hardwired panel/keypad zone)
Keypad Zone Number Assignment
Step Action
1 [ ] + [
ENTER INSTALLER CODE
2
Press and hold
3 [ ] + [
ZONE NUMBER
Delays
Step Action
1
+ [
INSTALLER CODE
2
3 [1] = Entry Delay 1 (default = 045 sec.)
[2] = Entry Delay 2 (default = 045 sec.)
[3] = Exit Delay
[4] = Bell Cut-Off
4 [000] to [255]
Time and Date
Step Action
1
+ [
INSTALLER CODE
2
+ [5]
4 [ : ]
HH MM
5 [ ]
TIME FORMAT
6 [ / / ]
YYYY MM DD
65
Details
] = flash. Programmed zones are lit (button or LED depending on keypad).
[
MAINTENANCE CODE
2 digits: 01 to 32
] Wireless zone = open/close cover or press learn/tamper switch. Hardwired zone =
Press [
ENTER
Refer to page 19 for the zone type (zone definition).
Assign the zone to one or both partitions and press [
] assigned to partition 1. Goes to next available zone.
ENTER
(Keypad Programming)
Details
] [ ] + [ ] = flash. [
ARM STAY
[ ] + [ ] = on.
ARM STAY
(3sec)
]* K32 / K32LCD / K32I = 2 digits: 01 to 32
ENTER
K636 / K10V/H = 1 digit: 1 to 0(10)
* To erase a keypad zone number, press [
Details
] = flash. [
MAINTENANCE CODE
(default = 060 sec.)
(default = 004 min.)
Entry/Exit Delay = seconds / Bell Cut-Off = minutes
Details
] = flash. [
MAINTENANCE CODE
Enter time. If
HH
Enter time format ([1] = 24hr; [2] = AM; [3] = PM).
Enter date.
] may also be used.
]. To erase a programmed zone, press [
] may also be used.
MAINTENANCE CODE
CLEAR
] may also be used.
] may also be used.
= 13 or more, skip to step 6.
] for 3 seconds.
SLEEP
]. By default, all zones are
ENTER
], then [ ].
ENTER
Programming Guide