Communication Programming - Paradox Magellan MG5050 Programming Manual

Communication Programming

[800] Dialer Options
Option
Telephone Line Monitoring (TLM) Options
[1]
OFF OFF
[1] & [2]
OFF
ON OFF
ON
[3]
Switch to pulse on 5
[4] Alternate dial
[5] Force dial (must be enabled to comply with TBR-21)
[6] DTMF dialing
[7]
Pulse ratio
[8] Reporting
[801] Dialer Options
Option
[1] Report system disarming
[2] Report zone restore
[3] [4]
OFF OFF Transmit the test report code every time the days programmed in section [840] have elapsed at the time programmed in
section [850] (default).
[3] & [4]
OFF ON When disarmed: Transmit test report code every time the time programmed in section [852] has elapsed. When armed:
Transmit test report code every time the time programmed in section [851] has elapsed.
ON OFF The control panel will transmit the test report code every hour on the minute value programmed in section [850] (the last
two digits). Note that the first two digits of section [850] will be ignored. E.g. If 10:25 was programmed into section [850],
the test report code would be transmitted at the 25th minute of every hour, i.e. 11:25, 12:25, etc.
ON ON The test report code will be transmitted when any of the conditions of the second and third options listed above (options
[3] = OFF and [4] = ON / options [3] = ON and [4] = OFF) are met.
[5] Contact ID Override
[6] to [8] N/A
[802] Event Call Direction Options 1
Option
[1] Call tel. #1 for arm/disarm report codes
[2] Call tel. #2 for arm/disarm report codes
[3] Call pager for arm/disarm report codes
[4] N/A
[5] Call tel. #1 for alarm/restore report codes
[6] Call tel. #2 for alarm/restore report codes
[7]
Call pager for alarm/restore report codes
[8] N/A
Magellan / Spectra SP
[2]
Disabled
When disarmed: Trouble only
ON
When armed: Trouble only
When disarmed: Trouble only
When armed: Audible alarm
Silent alarms become Audible alarm
ON
th
attempt
Auto-Test Report Transmission Options
OFF
See Table
Disabled
Disabled
Disabled
Disabled
1:2
Dialer activated
OFF
Always
Bell cutoff
Disabled
N/A
OFF
Disabled
Disabled
Disabled
N/A
Disabled
Disabled
Disabled
N/A
ON
See Table
Enabled
Enabled
Enabled
Enabled
1:1.5
No dialer
ON
After alarm
Zone closure
CID defaults / slow
format custom
N/A
ON
Enabled
Enabled
Enabled
N/A
Enabled
Enabled
Enabled
N/A
28