Before Upgrading The Wireless Card - Read This; Installation And Upgrade Of The Internal Nxt Components; Step 1: Remove The Existing Nxt Outer Housing - AMX Modero CV7 Operation/Reference Manual

CV7 Touch Panel Accessories

Before Upgrading the Wireless Card - Read This...

This new firmware file provides both backwards compatibility with the previous
802.11b cards and new security protocols for the new 802.11g wireless CF card.
1.
Upload the latest panel-specific kit file to your Modero touch panel and then confirm the firmware file
update was successful.
Each panel should be updated using its associated panel-specific kit file (SW2258_02 for the CV7). This
new firmware file provides both backwards compatibility with the previous 802.11b cards and new
security protocols for the new 802.11g wireless CF card.
If you don't first update the firmware file on the panel, before proceeding with the card
upgrade process, you will be required to configure NetLinx Studio to communicate
with the target panel via a direct USB connection.
In this communication scenario, your PC acts as a Virtual NetLinx Master establishing
a secure USB connection to the target panel and then uploading the new Kit file.

Installation and Upgrade of the Internal NXT Components

Upgrading the cards within the Table Top panel involves removing the outer housing (with speaker plate),
removing the existing card, replacing it with the 802.11g upgrade, and then placing the outer housing back
onto the NXT panel, as described in the following sections.
These panels do not come factory installed with the NXA-WC802.11GCF wireless interface card. This card
must be ordered separately from AMX as part of the 802.11g upgrade kit (FG2255-07).
Do not use Ethernet cables containing mounting boots. These boots could make
removal of the Ethernet connectors (from the panel) difficult and cumbersome.

Step 1: Remove the existing NXT Outer Housing

1.
Carefully detach all connectors from the rear of the touch panel and then gently place the touch panel
LCD facedown onto a soft cloth to expose the under-side of the base (FIG. 16). This step helps prevent
scratching of the LCD.
2.
Tilt the base forward so that both the bottom surface and Housing Screws are easily accessible.
Unscrew these four Housing Screws
to remove the Circuit Board Cover
FIG. 16 Location of the attachment screws underneath an NXT-CV7 panel base
18
DO NOT REMOVE these screws
They secure the plastic base front cover.
Base
Hinge Brackets (2)
Touch Panel
7" Modero Touch Panels